HTC NIKI160 User Manual download pdf (Page 229)

Appendix 229

Exposure to Radio Frequency (RF) Signals

Your device contains a radio transmitter and receiver. The radiated output power is

far below the international radio frequency exposure limits. These limits are part of

comprehensive guidelines and establish permitted levels of RF energy for the general

population. The guidelines are based on the safety standards previously set by

international standards bodies:

• American National Standards Institute (ANSI) IEEE. C95.1-1992

• National Council on Radiation Protection and Measurement (NCRP). Report 86.

1986

• International Commission on Non-Ionizing Radiation Protection (ICNIRP) 1996

• Ministry of Health (Canada), Safety Code 6. The standards include a substantial

safety margin designed to assure the safety of all persons, regardless of age and

health.

The exposure standard for wireless mobile phones employs a unit of measurement

known as the Specific Absorption Rate, or SAR. The standard incorporates a substantial

margin of safety to give additional protection for the public and to account for any

variations in usage.

As with other mobile radio transmitting equipment, users are advised that for

satisfactory operation of the equipment and for the safety of personnel, it is

recommended that no part of the human body be allowed to come too close to the

antenna during operation of the equipment.

Your device has an internal antenna. Use only the supplied integral antenna. Use of

unauthorized or modified antennas may impair call quality and damage the phone,

causing loss of performance and SAR levels exceeding the recommended limits as well

as result in non-compliance with local regulatory requirements in your country.

To assure optimal phone performance and ensure human exposure to RF energy is

within the guidelines set forth in the relevant standards; always use your device only

in its normal-use position. Do not touch or hold the antenna area unnecessarily when

placing or receiving a phone call. Contact with the antenna area may impair call quality

and cause your device to operate at a higher power level than needed. Avoiding

contact with the antenna area when the phone is IN USE optimizes the antenna

performance and the battery life.

Body-worn measurements were tested for typical body-worn operations with the back

of the device kept 1.5 cm from the body.

SAR Information

0.344 W/Kg@10g (Head), 1.590 W/Kg@10g (Body)

1 2 ... 224 225 226 227 228 229 230 231 232 233 234 ... 239 240

No comments

HTC NIKI160 User Manual Page 229