HTC NM8LIBR100 User Manual download pdf (Page 107)

Appendix 107

The M mark is intended to be synonymous with the U mark. The T mark is intended to be synonymous

with the UT mark. The M and T marks are recommended by the Alliance for Telecommunications Industries

Solutions (ATIS). The U and UT marks are referenced in Section 20.19 of the FCC Rules. The HAC rating and

measurement procedure are described in the American National Standards Institute (ANSI) C63.19 standard.

For information about hearing aids and digital wireless phones

FCC Hearing Aid Compatibility and Volume Control:

http://www.fcc.gov/cgb/dro/hearing.html

Gallaudet University, RERC:

http://tap.gallaudet.edu/DigWireless.KS/DigWireless.htm

SAR Information

• 1.490 W/kg @1g (Head)

• 1.380 W/kg @1g (Body)

THIS MODEL DEVICE MEETS THE GOVERNMENT’S REQUIREMENTS FOR EXPOSURE TO RADIO WAVES.

Your wireless mobile CDMA phone is a radio transmitter and receiver. It is designed and manufactured not to

exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications

Commission of the U.S. Government. These limits are part of comprehensive guidelines and establish

permitted levels of RF energy for the general population. The guidelines are based on the safety standards

previously set by both U.S. and international standards bodies:

• American National Standards Institute (ANSI) IEEE. C95.1-1992.

• National Council on Radiation Protection and Measurement (NCRP). Report 86. 1986.

• International Commission on Non-Ionizing Radiation Protection (ICNIRP) 1996.

• Ministry of Health (Canada), Safety Code 6. The standards include a substantial safety margin designed

to assure the safety of all persons, regardless of age and health.

The exposure standard for wireless mobile CDMA phone employs a unit of measurement known as the

Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg*. Tests for SAR are conducted with

the device transmitting at its highest certified power level in all tested frequency bands. Although the SAR

is determined at the highest certified power level, the actual SAR level of the device while operating can be

well below the maximum value. This is because the device is designed to operate at multiple power levels

so as to use only the power required to reach the network. In general, the closer you are to a wireless base

station antenna, the lower the power output. Before a device model is available for sale to the public, it must

be tested and certified to the FCC that it does not exceed the limit established by the government adopted

requirement for safe exposure. The tests are performed in positions and locations (e.g., at the ear and worn on

the body) as required by the FCC for each model.

The highest SAR value for this model device when tested for use at the ear is 1.490 W/kg @ 1g and when worn

on the body, as described in this user guide, is 1.380 W/kg @ 1g. (Body-worn measurements differ among

device models, depending upon available accessories and FCC requirements). While there may be differences

between the SAR levels of various devices and at various positions, they all meet the government requirement

for safe exposure.

The FCC has granted an Equipment Authorization for this model device with all reported SAR levels evaluated

as in compliance with the FCC RF exposure guidelines. SAR information on this model device is on file with

the FCC and can be found under the Display Grant section of https://gullfoss2.fcc.gov/prod/oet/cf/eas/

reports/GenericSearch.cfm after searching on FCC ID: NM8LIBR100.

Additional information on Specific Absorption Rates (SAR) can be found on the Cellular Telecommunications

& Internet Association (CTIA) web-site as http://www.phonefacts.net.

1 ... 106 107 108 ... 118

Comments to this Manuals

No comments

HTC NM8LIBR100 User Manual Page 107

Comments to this Manuals

Related products and manuals for Mobile phones HTC NM8LIBR100