Htc DS18DMR User Manual download pdf (Page 21)

English

OPERATION

1. Using the light equipped hook

WARNING: When using the hook, pay sufficient attention so that the main

equipment does not fall. If the tool falls, there is a risk of accident.

CAUTION:

● Do not attach the tip tool except phillips bit to the tool main unit when carrying the

tool main unit with the hook suspended from a waist belt.

Injury may result if you carry the equipment suspended from the waist belt with sharp

tipped components such as drill bit attached.

1.1 Using the hook

The hook can be installed on the right or left side

and the angle can be adjusted in 5 steps between

0° and 80°.

(1) Operating the hook

(a) Pull out the hook toward you in the direction

of arrow (A) and turn in the direction of arrow

(B). (Fig. 9)

(b) The angle can be adjusted in 5 steps (0°, 20°,

40°, 60°, 80°).

Adjust the angle of the hook to the desired

position for use.

(2) Switching the hook position

CAUTION:

● If the tool falls, there is a risk that malfunction

and/or physical damage can occur. It is

recommended that you also use fall-preventing

wires, etc.

● Incomplete installation of the hook may result in

bodily injury when used.

(a) Securely hold the main unit and remove the

screw using a slotted head screwdriver or a

coin. (Fig. 10)

(b) Remove the hook and spring. (Fig. 11)

and securely fasten with screw. (Fig. 10)

Hook

(A)

(B)

Fig. 11

Fig. 9

Fig. 10

Loosen

Spring

Hook

Screw

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 91 92

Comments to this Manuals

No comments

Htc DS18DMR User Manual Page 21

Comments to this Manuals