Htc Z5426 User Manual download pdf (Page 44)

English-44

MAINTENANCE

EZT belt

To replace EZT (E-Series Zero Turn Transaxle) belt

Park the mower on a level surface. Engage the

parking brake.

EZT belt removal

NOTE: Be careful not to damage the fan blades on the

EZT´s as this can affect cooling or damage the EZT´s

• Remove the deck belt (see to replace deck belt in

this section of the manual).

• Unplug clutch from wiring harness. Remove bolt from

center of clutch and slide clutch off of engine shaft.

• Create slack in the belt by removing the spring on the

pump idler arm.

• The belt should now be able to be removed from the

engine pulley and EZT pulleys.

Belt installation

• Wrap the EZT belt around the EZT pulleys

• Route the belt around the inside of the idler pulley.

• Now you can wrap the belt around the engine

pulley.

• Reattach the spring on the pump idler arm.

• Install clutch on to engine shaft (pulley side down)

make sure key is installed and align the clutch

anti-rotation tab into slot on clutch. Secure clutch,

install wire.

• Reinstall the deck belt onto the electric clutch belt

(see to replace deck belt in this section of the

manual).

Transaxle belt

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 75 76

No comments

Htc Z5426 User Manual Page 44