Htc AM171 User Manual download pdf (Page 147)

Appendix 147

Controls

Device Control TouchFLO™ 3D

Touch-sensitive navigation control with ENTER button

HOME button

BACK button

Phone buttons: TALK/SEND and END

POWER button

VOLUME CONTROL buttons

RESET button

•

Others

Special Features GPS and A-GPS ready (GPS navigation software not included)

A.2 Regulatory Notices

Regulatory Agency Identifications

For regulatory identification purposes, your product is assigned a model number of DIAM500.

To ensure continued reliable and safe operation of your device, use only the accessories listed below with

your

DIAM500.

The Battery Pack has been assigned a model number of

DIAM171.

Note This product is intended for use with a certified Class 2 Limited Power Source, rated 5 Volts DC, maximum 1 Amp

power supply unit.

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant

to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful interference

to radio communications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the interference by

one of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio or television technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance

could void the user's authority to operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)

This device may not cause harmful interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

IMPORTANT NOTE

Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End

users must follow the specific operating instructions for satisfying RF exposure compliance. To maintain

compliance with FCC RF exposure compliance requirements, please follow operation instruction as

documented in this manual.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter,

except the transmitters built-in with the device.

•

1 2 ... 142 143 144 145 146 147 148 149 150 151 152 ... 157 158

Comments to this Manuals

No comments

Htc AM171 User Manual Page 147

Comments to this Manuals

Related products and manuals for PDAs Htc AM171