HTC RAPH100 User Manual download pdf (Page 35)

Getting Started 35

Auto configure the data connection settings

The first time you power on your device, you will

see a notification message from Connection

Setup. Connection Setup automatically configures

your device’s data connections, such as 3G/GPRS,

WAP, and MMS, so that you do not need to enter

the settings manually for your device.

To automatically configure data connection

settings

1. When you see the notification message from

the Connection Setup, tap Yes.

Note If you do not see the notification message, tap the title bar to display the System

Status screen, then tap on the title bar to display the message.

2. If your SIM card supports multiple network operator profiles, a message will

appear with network profile choices. Select the profile you want to use and

tap OK.

3. Connection Setup then starts to configure your device’s data connection

settings.

4. After the Connection Setup completes the configuration, tap Restart.

For more information about Connection Setup, see Chapter 13.

Switch to Sleep mode when not in use

Press and immediately release the POWER button to turn off the display temporarily

and switch your device to Sleep mode. Sleep mode suspends your device to a low

power state while the display is off in order to save battery power.

Your device automatically goes into Sleep mode when you leave the device idle

after a certain period of time. You will still be able to receive messages and calls

while your device is in Sleep mode. Pressing the POWER button again, removing

the stylus, or incoming calls/messages will wake up your device.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 309 310

No comments

HTC RAPH100 User Manual Page 35